The best non-technical method used to adjust the back up lamp switch is to place the shifter in reverse, attach the switch rod to both the switch and the reverse rod and then move the switch until the back up lamps come on.
Installation of the rod is easy if it is installed in the correct hole. There is only one hole in the shifter lever, but there are multiple holes in the switch and the rod installs in the long lever with the single hole. You’ll notice there is a divot above the hole in the picture below.
Corvette Parts, Service and Sales 800-588-3883 Orders Rear End Cushion Replacement. (snubber) Do you hear a thump when you move your car from reverse to forward? If so, odd’s are your rear end cushion (snubber cushion) needs replaced. This cushion … Continue reading
Typically we called this the old fart vacuum chart. Or what does my vacuum gauge tell me. On a typical engine: Steady 17-22 hg = normal engine operation. Low but steady = Late ignition, valve timing or low compression. Very … Continue reading
The main differences between the two egg crates are the following; the 1970 egg crates did not have painted edges at the end of the louver box. On the 1971-1972 versions, there was a raised lip that was chrome plated … Continue reading